Flame signal converter

Flame signal converter 3007

The flame signal converter 3007 resolves the flame signal of the associated flame scanner and provides a current signal (0/4...20 mA) for external processing, linear to the measured flame intensity.

Catalog Get a quote Contact us

Description

The flame signal converter 3007 is a system plug-in unit of the 3000 series. It resolves the flame signal of the associated flame scanner and provides a current signal (0/4...20 mA) linear to the measured flame intensity for further external processing. The plug-in units work completely independently of the parallel assigned flame monitor 3001, 3001D or 3001S. While the settings on the flame monitor are optimized for the highest possible availability with maximum safety, the flame signal converter can focus on the flame radiation analysis. This means that changes in flame intensity are displayed well in advance, before unstable flame monitor signals occur, which may also cause the burner to shut down. If secondary effects can be ruled out (dirty flame sensor optics, misalignment or absorption by smoke or dust), signals are obtained that allow changes in combustion to be recognized immediately by the flame image. Corrective measures can be taken in good time. In combination with appropriate radiation sensors, increases in emission values can also be prevented. The output signals of the 3007 flame signal converters are either integrated directly into the burner control system or used for visualization by means of a process signal display (usually via monitors).

Technical Data

Measuring ranges:

0 - 800
0 - 400
0 - 200 Flame evaluator display
0 - 100 3001D, 3003, 3103 or similar
0 - 50
OFF

Number of measuring channels: 4

Measuring range selection: Rotary switch in the front panel
Measurement output:

0/4 - 20 mA (switchable via jumper)
Load max. 500

Measurement error: less than 1% of the final value
Supply voltage: 24 V DC
Current consumption: approx. 340 mA
Operating temperature: -20 °C to +70 °C

Applications

Downloads

Accessories

Everything you need

Do you have a question about our service portfolio, need planning support for a project or are you looking for a specialist in flame monitoring? Then please contact us.

10. April 2025

Built-in / surface-mounted housing

For 1-6 slide-in units System 3000/4000 to DIN 41494.

Learn more

10. April 2025

Ex wall-mounted enclosure

Do you have a question about our Ex wall-mounted enclosure, need planning support for a project or are you looking for a specialist in the field of flame monitoring? Then contact us. We are here for you.

Learn more

This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.